ESD-Simulator SESD 230 | 30 kV

IEC / EN 61000-4-2

The test generator SESD 230 simulates electrostatic discharge as defined in the standard IEC / EN 61000-4-2. Higher test levels can be set far beyond the standard limits.

Request a quote now

Two test methods are used depending on the test specimen and test setup:
Air discharge (AIR) and Contact discharge (CON)

We will gladly advise you personally!
+49 (0) 89 69 3142 35-0

  • Air discharge: ±0.2 kV up to ± 30 kV
  • Contact discharge: ±0.2 kV up to ±30 kV 
  • Output voltage: adjustable via potentiometer
  • Polarity: positive and negative
  • Holding time: >5 sec
  • Pre selectable counter: 1 - 9999
  • Discharge resistor: according to IEC / EN 61000-4-2
  • Energy storage capacity: 150 pF ± 10%
  • Discharge resistance: 330 Ohm ± 5%
  • Weight ESD gun: approx. 1470 g

In a practical carrying case with accessories:

  • 2 discharge tips (AIR/CON)
  • Ground cable
  • Battery charger incl. cable

The simulator operates on battery power. If the battery is empty, it can immediately be charged with the charger provided. Loading bar in the display indicates the charging status.
No change of the battery required! (According to experience replacement battery are also empty if you need them).

The simulator has a "Contact control". When testing "CON" touches the test tip the surface of the EUT. When not contacted, will be no triggering of the pulse. The display shows "No contact". This ensures that at contact discharge actually occurs a discharge.

Request a quote now
Data sheets
ESD-Simulator, SESD 230
Accessories
Horizontal Coupling Plane (HCP), Ground reference plane Vertical Coupling Plane (VCP) Earth cable ESD Verification Set Transport case - ESD Verification set Test tip - special Support arm with balancer Hook for balancer Silicon sheet (IEC/EN 61000-4-2) Silicon sheet (ISO 10605) ESD remote control software